Wednesday, August 13, 2014
Browse |
home»
alarm
»
door
»
fridge
|
Fridge door Alarm
This schema, enclosed into a small box, is placed in the fridge near the lamp (if any) or the opening. With the door closed the interior of the fridge is in the dark, the photo resistor R2 presents a high resistance (>200K) thus clamping IC1 by holding pin 12 high. When a beam of light enters from the opening, or the fridge lamp illuminates, the photo resistor lowers its resistance (<2k),>
Parts:
R1____________10K 1/4W Resistor
R2___________Photo resistor (any type)
R3,R4________100K 1/4W Resistors
C1____________10nF 63V Polyester Capacitor
C2___________100µF 25V Electrolytic Capacitor
D1,D2_______1N4148 75V 150mA Diodes
IC1___________4060 14 stage ripple counter and oscillator IC
Q1___________BC337 45V 800mA NPN Transistor
BZ1__________Piezo sounder (incorporating 3KHz oscillator)
SW1__________Miniature SPST slide Switch
B1___________3V Battery (2 AA 1.5V Cells in series)
Notes:
* Connecting D1 to pin 2 of IC1 will halve the delay time.
* Delay time can be varied changing C1 and/or R3 values.
* Any photo resistor type should work.
* Quiescent current drawing is negligible, so SW1 can be omitted.
* Place the schema near the lamp and take it away when defrosting, to avoid schema damage due to excessive moisture.
* Do not put this device in the freezer.
Fridge door Alarm
Parts:
R1____________10K 1/4W Resistor
R2___________Photo resistor (any type)
R3,R4________100K 1/4W Resistors
C1____________10nF 63V Polyester Capacitor
C2___________100µF 25V Electrolytic Capacitor
D1,D2_______1N4148 75V 150mA Diodes
IC1___________4060 14 stage ripple counter and oscillator IC
Q1___________BC337 45V 800mA NPN Transistor
BZ1__________Piezo sounder (incorporating 3KHz oscillator)
SW1__________Miniature SPST slide Switch
B1___________3V Battery (2 AA 1.5V Cells in series)
Notes:
* Connecting D1 to pin 2 of IC1 will halve the delay time.
* Delay time can be varied changing C1 and/or R3 values.
* Any photo resistor type should work.
* Quiescent current drawing is negligible, so SW1 can be omitted.
* Place the schema near the lamp and take it away when defrosting, to avoid schema damage due to excessive moisture.
* Do not put this device in the freezer.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment