Circuit knowledge

Showing posts with label mosfet. Show all posts

Wednesday, September 24, 2014

Power Inverter 1000 Watt by Mosfet

This power inverter circuit will provide a very stable “Square Wave” Output Voltage. Frequency of operation is determined by a pot and is normally set to 60 Hz. Various “off the shelf” transformers can be used. Or Custom wind your own for best results.

Additional MosFets can be paralleled for higher power. It is recommended to Have a “Fuse” in thePower Line and to always have a “Load connected”, while power is being applied. The Fuse should be rated at 32 volts and should be aproximately 10 Amps per 100 watts of output.

The Power leads must be heavy enough wire to handle this High Current Draw! appropriate Heat Sinks Should be used on the RFP50N06 Fets. These Fets are rated at 50 Amps and 60 Volts. Other types ofMosfets can be substituted if you wish.

Note
There ARE Limitations! I have had numerous requests for an Inverter for 1000 watts and Even MORE. Sorry I Don’t feel this is Practical. At 1000 Watts and operating from a 12 Volt Source, the Input Current will be close to 100 AMPS. That would Require a HUGH Size of a Primary Wire.

Friday, August 29, 2014

Mosfet power amplifier schematics

This simple mosfet power audio amplifier circuit, with TL071C and 2 mosfet power amplifiers can deliver up to 45W on 8 ohm. This schematic is based on Siliconix application and is based on variations of voltage on the 2 resistors serial inserted on the voltage supplier of the operational amplifier driver.
The MosFet transistor must be mounted on a heatsink at least 1K/W.

Amplifier efficiency is 70%, distortions at cut frequency were at most 0.2% at 20Hz on 8ohm and 10W. With a power supply of +- 30V the mosfet audio amplifier can deliver 45W on 8 ohm and 70w on 4 ohm. Remember that this audio amplifier is not protected on shortcircuits so everytime you switch on check to see if the speaker is connected.

source [link]